What to do if my TaoTronics TT-AH002 LED is off and it doesn't work?
If the LED indicator is off and the unit isn't working, it could be due to: * **No power supply**: Connect the power supply. * **Unit not powered on**: Turn the switch to power on the unit.
Why does my TaoTronics Humidifier have a bad smell?
A bad or strange smell from your TaoTronics Humidifier can be due to a couple of reasons: * If it's a **new unit**: Take out the water tank, open the cover, and let it sit in a room without operating for at least half an hour. * If you are using **dirty water or the water has been stored for too long**: Clean the water tank and refill it with clean, fresh water.
How to fix a TaoTronics Humidifier with low mist output?
If the mist output of your TaoTronics Humidifier is too small, it could be caused by: * **Stain buildup on the transducer**: Clean the transducer. * **Dirty water or water stored for too long**: Clean the water tank and refill with fresh, clean water. * **Water is too cold**: Add some warm water.
What to do if the LED indicator on my TaoTronics TT-AH002 Humidifier is red, but there's no mist or wind?
If the LED indicator is red but there is no mist or wind, check the following: * **No water in the water tank**: Fill the water tank. * **Too much water in the water sink**: Pour out some water from the water sink and ensure the water tank cover is tightly closed.
Why is my TaoTronics Humidifier making abnormal noises?
Abnormal noise from your TaoTronics Humidifier can be caused by: * **Lack of water**: Fill the water tank with water. * **Unstable surface**: Move the unit to a stable, flat surface.
Why is the water tank leaking on my TaoTronics TT-AH002 Humidifier?
If the water tank is leaking, consider the following: * **Tilted surface**: Place the unit on a flat surface. * **Incorrect installation**: Ensure the water tank is correctly installed as instructed in the user manual. * **Loose tank cap**: Tightly close the tank cap. Avoid separating the water tank from the base while the unit is working.
Why is my TaoTronics TT-AH002 Humidifier's LED and wind on, but there is no mist?
If the LED indicator and the wind are on, but there's no mist, the mist output might be set to the lowest level. Try adjusting the mist output to a higher level.
What causes mist overflow from the tank or nozzle of my TaoTronics Humidifier?
Mist overflowing from the tank or around the nozzle may be due to a gap between the water tank and the base, or between the nozzle and the tank. Try putting some water around the surface of the water sink and wetting the nozzle before using.
What to do if my TaoTronics TT-AH002 Humidifier shows no water, but the tank is full?
If the LED indicator is on and the water tank has water, but it still indicates no water, the floater might be jammed. Stir the floater to ensure it flows smoothly.
What to do if water doesn’t go down to the sink in my TaoTronics TT-AH002 Humidifier?
If water isn’t going down to the sink, the filter may be blocked. Clean the filter.
Adjustable evaporation level from 0 - 300 mL/h.
Indicates the working status of the humidifier.
Removes water bacteria and bad odor from the mist.
Automatically powers off when water level is depleted.
General| Model | TT-AH002 |
|---|---|
| Mist Output | 300 ml/h |
| Run Time | Up to 30 hours |
| Dimensions | 8.66 x 6.1 x 11.81 inches |
| Weight | 3.5 lbs |
| Humidistat | No |
| Noise Level | < 36 dB |
| Power Consumption | 25W |
| Timer | No |
| Type | Ultrasonic Humidifier |
| Water Tank Capacity | 4L |
| Features | 360° Nozzle, Adjustable mist output |
| Coverage Area | 322 sq. ft |
To Next Page