Product Diagram
⑴ Nozzle
⑵ Water Tank Lid
⑶ Water Tank Handle
⑷ Water Tank
⑸ Filter
⑹ Water Inlet Cap
⑺ Cleaning Brush
⑻ Tank LED Light
⑼ Air Inlet
⑽ Power Cable
⑾ Pour Side
⑿ Safety Lock
⒀ Base
⒁ LED Display
⒂ Touchpad
03/04
Adding Water
• Turn the safety lock counter-clockwise by 90 degrees to unlock the
water tank.
• Remove the water tank lid, lift the water tank from the base, and place it
upside down to access the water tank cap.
• Rotate the tank cap counterclockwise to remove the cap and add
clean water into the tank. Make sure water does not overow.
Note: Please rotate the cap gently; do not screw with too much force to
avoid hurting your hand or the product.
• Put the cap back on the tank and screw clockwise to lock in place. Stop
twisting when no water comes out.
• Put the water tank back on the base.
• Turn the safety lock by clockwise 90 degrees to lock in place.
How to Use
• Power on the humidier. The unit now is in standby mode and the current
relative humidity (RH) will be shown on the display. You can operate the
humidier through:
⑴
⑵
⑶
⑷
⑸
⑹
⑺
⑻
⑼
⑽
⑾
⑿
⒀
⒁
⒂
To Next Page
Loading...
Need help?
General
