LED Indicators
LED indicator
Solid red
Solid green
Flashes green and red alternately
Flashes green once every 5 seconds
Flashes green once every 10 seconds
Flashing red
Status
Charging
Fully charged
In Pairing mode
Disconnected from Bluetooth device
Paired with a Bluetooth device
Low battery
▲Note: The headphone will not automatically connect to a Bluetooth device when
switched on, please read the next section on how to connect to your Bluetooth device.
How to Use
1. Charging
1) Connect the charging port with any USB charging adapter or
active computer USB port
2) Charging will start automatically with LED indicator turning red
3) The headphone is fully charged when LED indicator turns green
2. Pairing
1) Make sure the headphone and your Bluetooth device are next to each other (within 3 feet)
2) Press and hold the Multifunction button for 5 seconds to bring the headphone into
pairing mode with the LED indicator ashing green and red alternately
3) Activate Bluetooth function on your phone and search for the nearby Bluetooth
connection:
• For iPhone: Settings > Bluetooth > On
• For Android: Settings > Wireless & Networks > Bluetooth: On > Scan for devices
4) Find “TaoTronics TT-BH09” in the search results. Tap on the name to connect. Once
connected, only the green LED will ash once every 10 seconds
Note:
• If a PIN code is required for pairing, please try “0000” or “8888” (4 zero or 4 eight)
• The Bluetooth headphone can remember previous paired devices. If you have
previously paired the headphone with a device, simply turn on your device and the
headphone (by pressing the Multifunction button for 3 seconds to turn on), they will
connect the last connected device automatically without going into pairing mode.
3. Pairing with two devices at the same time
Although you can pair with two devices, only one of them can play music or make
phone call with the headphone at any time. To pair with two devices:
1) Follow previous instructions in the “Pairing” section to pair the
TT-BH09 with your rst device
2) Turn off the Bluetooth function of your rst device, follow the “Pairing” instructions again
to pair and connect to your second device
3) With Bluetooth function on both devices turned on, simply restart the headphone, it
will connect to the last connected device automatically, while the other
device needs to connect manually
4) To switch between the two paired devices, simply pause the music on the rst device
and play music on the second device or vice versa
4. How to Wear
Please wear the headphone as shown in the diagram:
05/06
To Next Page
Loading...
Need help?
General
