Troubleshooting on using this scanner
1. How to get into manual mode?
Please hard press the yellow trigger for 8 about seconds. Please keep in mind that
manual mode cannot be setup everlasting. It will enter into auto mode once it plug out
your PC and plugged in again
2. Can the scanner read QR code?
No, our scanner is just a 1 D scanner.
3. Why cannot I enter into setup mode?
To enter into Setup mode, a RS232 cable is required. What’s more this kind mode
requires a knowledgeable person on this mode and must be very familiar with scanners.
We’d suggest our customers send us E-mails instead of set up scanner into this mode
when they have any special needs since we haven’t provide this kind cable in the
products
4. How to get into factory default?
Scan the bar code Defaults
5. How to disable the auto Tab function?
Scan the bar code below:
6. Why cannot my scanner read ISBN NO?
Scan the bar code below:
Convert EAN-13 to ISBN Enable
-10-
To Next Page
Loading...
Need help?
General
