20
3.2.5 Network
On this page, you can use the Enable function to enable or disable the
network by switching the Enabled button on / off.
Ethernet settings can be viewed on the left tab, while Wi-Fi settings
are found on the right tab. No matter what form of network you
choose, the software will automatically obtain the MAC address, IP,
and DNS information.
After connecting to your Wi-Fi, tap “Apply”. In Wi-Fi mode, select
Client. You then need to exit the Network menu before entering
again. After a successful connection, the router address and
gateway information will appear. Meanwhile, the Wi-Fi light will blink
green 3 times every 3 seconds.