Tapworks AD11 User And Installer Handbook

12
Please Remember – Only use tablet or pellet salt in your softener!
Programming the AD11 and AD15 Faceplate (cont)
To increase or decrease the displayed number to your required setting use
the s or t buttons.
Once the required setting is displayed it may be set by pushing the
SELECT button once more.
SET THE RECHARGE TIME
The display will flash 02.00 recharge time, which is the pre-set factory
setting. If you wish to change this time then proceed as follows:
(if not, press SELECT. Programming is complete).
Note: 2.00am is chosen because any household water used during
recharge will be replaced with hard water. Consequently a time is
required when very little, if any, water will be used. To select a different
recharge time use the s or t buttons, to adjust one hour at a time.
Once the required setting is displayed it may be set by pressing the
SELECT button once more. Recharge will last for approximately 1 hour.
Programming is complete. Proceed to Finishing Installation
(please refer to page 16)
1 5
HARDNESS
2: 00
AM
PRESENT TIME

Tapworks AD11 Specifications

General

Brand	Tapworks
Model	AD11
Category	Water Dispenser
Language	English