Manual recharge
The water softener will automatically recharge when it needs to. The factory setting for the recharge is 2am. There may be occasions when
you need to do a manual recharge, for example more people staying in the home than usual.
TO RECHARGE NOW – simply press the TOUCH/HOLD BUTTON
and hold it down for approximately 3 seconds, until a beep sounds.
Recharge will flash on the display.
The process will take a few minutes
to begin and lasts approximately
1 hour. It cannot be cancelled
once started
TO RECHARGE TONIGHT – the unit can be programmed to recharge
at the next pre-programmed time, regardless of its remaining capacity.
Simply press the TOUCH/HOLD button
once. Recharge tonight will flash on
the display.
To cancel recharge tonight, press the
TOUCH/HOLD button once and
immediately release. The display will
return to the time display.
NOTE: Use as little water as possible during a recharge as hard water will bypass the water softener.
Once the recharge is complete the recharge display will disappear.
9:
10
AM
RECHARGE TONIGHT
1 1
:00
AM
RECHARGE
Please Remember – Only use tablet or pellet salt in your softener!
21