Tapworks AD11 User And Installer Handbook

14
Programming the Ultra 9 Faceplate (cont)
Please Remember – Only use tablet or pellet salt in your softener!
When the transformer is first plugged in, the display will flash 12.00am.
Note: Each time you press a button on the fascia panel display,
a beeper sounds. One beep signals that a change is accepted. If the beeper
sounds continually then a different button is required to affect the operation.
SET THE PRESENT TIME
The display will continue to flash and the time can be advanced or moved
backwards using the s or t buttons. Holding down the buttons advances
the time at a faster rate.
If the time requires changing during normal operation, press the SET button
once. The display will flash and indicate present time.
You may use the s or t buttons as described above to alter the time. Once
the required time is displayed the time may be set by pushing the SET button
once more.
SET THE WATER HARDNESS CALCULATION
The display will flash ’25 hardness’ (this is a pre-set
factory setting). Hardness varies from one location
to another. Use the kit provided to determine your
water hardness in ppm. If necessary change to the
unit setting indicated.
2 5
HARDNESS
ppm Unit Setting
(170) 10
(190) 11
(200) 12
(220) 13
(240) 14
(255) 15
(270) 16
(290) 17
(300) 18
(325) 19
(340) 20
(360) 21
(380) 22
(400) 23
(420) 24
(440) 25
(460) 30
(480) 30
(500) 35
WATER HARDNESS

Tapworks AD11 Specifications

General

Brand	Tapworks
Model	AD11
Category	Water Dispenser
Language	English