Tapworks AD11 User And Installer Handbook

7
Please Remember – Only use tablet or pellet salt in your softener!
Step-by-step guide to plumbing the softener (cont)
FIT THE INLET AND OUTLET ADAPTOR ELBOWS
Remove the plastic plug from the outlet port on the water softener valve, if present. Adaptor elbows are
pre-fitted with a single ‘O’ ring to the outer groove. Push the adaptors into the valve inlet as far as they
will go. Lightly lubricate using the silicone grease provided.
Note: Do not use petroleum jelly or oil based lubricants
Note: See diagram opposite for ‘O’ Ring location (pre-fitted)
Spare ‘O’ rings are supplied only if required.
Turbine Located
Inside
‘O’ Ring
‘O’ Ring
Inlet
Outlet

Tapworks AD11 Specifications

General

Brand	Tapworks
Model	AD11
Category	Water Dispenser
Language	English