THIS IS IMPORTANT TO YOUR SAFETY.
PLEASE TAKE A MINUTE TO READ IT CAREFULLY
BEFORE SWITCHING ON YOUR NEW HEATER.
2. Insert Plug into Power Point and switch on.
3. Turn the Thermostat control down
(anticlockwise) until you hear it click off.
QUICK START GUIDE
If you have any query, please feel free to call our friendly customer service team
on our toll free number: 1800 079 124 or via email info@hegroup.com.au.
90cm
Note: Do not use with power boards or
double adaptors, etc. as it may overload
your power point and trip your power.
90cm
1. After fitting the castor wheels as per the
instructions, place heater on a flat surface
ensuring there is at least 90cm clearence
all around and over the top of the heater.
Do Not Place items on or against the heater.
4. Switch either or both switches to
the “I” or / and “II” postion. The indicator light
in the switch will illuminate.
“I” Only is Low Heat
“II” Only is Medium Heat
“I & II” is High Heat
“O” is OFF
Ensure the switch in the
timer is set to “I” for manual
operation.
5. With the heat selector switches set to either
“I”, “II” or “I and II”, turn the thermostat control
up slowly (clockwise) until you hear it click On.
The heater will now start to heat. Adjust up or
down to your desired temperature setting.
Note: As the thermostat
maintains room temperature
it will switch on and off. As it
switches on and off, you may
notice a blue flash from
inside the heater.
This is not dangerous and
is no cause for alarm.
6. Do Not Operate while unattended
Press the heat selector swithces to position
“O” (off), then turn power off at the power
point and unplug. Always Unplug when not
in use.
To Next Page
Need help?
General