Link Button
Receiver Link Button (PAUM005)
The receiver’s status light glows blue when the receiver is
activated.
2 Press and release the reset button, located on the bottom of the
mouse.
CAUTION: Pressing and holding the reset button longer than
1.5 seconds may cause the mouse to enter power off mode.
See “ Powering the Mouse Off and On” below.
Mouse Reset Button (PAUM005)
Mouse Reset Button (PAUM005)
The mouse’s red light emitter diode (LED) stops glowing
when you press the reset button and resumes glowing when
the button is released.
You are now ready to use the RF mouse.
Powering the Mouse Off and On
To power off the mouse:
1 Press any key to wake the mouse (if it’s in sleep mode).
2 Press and hold the reset button for at least two seconds.
030704 PAUM006Add2r_eng.fm Page 2 Friday, July 4, 2003 3:40 PM
To Next Page
Loading...
