Targus PAUM005 - User Manual

READ ME FIRST FOR
FIRST TIME INSTALLATION
ATTENTION !
Targus Wireless RF Mouse Users
Before You Begin
After your computer detects the USB receiver and the driver
software is installed, you must establish a communications link
between the mouse and its receiver BEFORE you can use the
mouse. To establish this link, you need to set the identification code
so that the mouse works properly. To do this, follow the
instructions for your mouse model.
NOTE: This addendum replaces the section titled “Establishing a
Communications Link (All RF Mouse Models)in the supplied
user’s guide.
Mouse Model PAUM005
Establishing a Communications Link
Make sure that your computer is turned on and has detected the
USB receiver before you establish a communications link.
1 Press and release the link button on the receiver.
030704 PAUM006Add2r_eng.fm Page 1 Friday, July 4, 2003 3:40 PM

Targus PAUM005 Specifications

General

Brand	Targus
Model	PAUM005
Category	Mouse
Language	English

Summary

Getting Started with Targus Wireless RF Mouse

Initial Setup for PAUM005

Establish a communications link for PAUM005 mouse and receiver before use.

PAUM005 Receiver Link Button

Details on the receiver's status light and link button operation.

PAUM005 Mouse Reset Button

Instructions for the mouse reset button and power off mode caution.

Setup for Mouse Model PAUM006

Establishing Communications Link for PAUM006

Steps to link the PAUM006 mouse and receiver and status light behavior.

Important Usage Information

Battery Management

Guidelines for battery replacement and extending battery life.

Sleep Mode Functionality

Details on automatic sleep mode activation and waking the mouse.