NOTE: You may need to press the mouses link button more
than once if the receivers status light does not glow red.
The receivers status light flashes while it scans the
identification codes for the mouse. Once a valid code is
selected, the status light stops flashing.
3 To use the mouse, press any button.
Things to Remember
Batteries
General
• You must establish a communications link every time you
change the batteries.
• To extend the life of your batteries, remove them from the mouse
while traveling.
PAUM005
• You should change the batteries when the LED on the scroller
wheel glows blue.
PAUM006
• You should change the batteries every two to three months,
depending on how often you use the mouse
Sleep Mode
• The mouses sleep mode feature activates after 8 minutes of non-
operation.
• To wake the mouse from sleep mode, press any button.
030704 PAUM006Add2r_eng.fm Page 4 Friday, July 4, 2003 3:40 PM
To Next Page
Loading...
