Tascam DA-98 - Saving Digital 328 User Setups; Tascam DA-78 HR Setup

Tascam DTRS Setup Guide
5
Once the Machine Type has been selected, the timecode source must be selected.
The frame rate must also be selected. The options are 24 frame, 25 frame, 30 drop frame and
30 non-drop frame. Whichever is selected here must also be selected later when setting up the
DTRS.
Enter the Menu pages by pressing the <MENU> button and scroll through the menus until ‘User
Setups’ is highlighted. Press <ENTER> and scroll through to find a vacant setup location. Press
<STORE> in the Snapshot section of the Select Panel on the 328. The Setup will now be
stored. To edit the parameters of the setup, while the setup is highlighted in the display, press
<ENTER>. To recall the setup, highlight it in the Setup menu in the LCD and press the
<RECALL> button in the snapshot section of the Select Panel.
<T
ape
M
ac
h
S
e
t
up
>
Tascam DTRS
Tascam DTRS
Timecode Src:MTC
T
ascam
DTRS
F
rame Rate: 25
<
S
e
t
up#
01
>
ID :Tascam DA88
For MMC operation of the DA-38, the MMC-38 unit must be used and
selected in the Tape Machine Setup menu.
NOTE
MIDI Timecode (MTC) must be selected as the DA-88 does not transmit
SMPTE (LTC).
NOTE
Once the 328 has been set up, it is very advisable to store a User
Setup of the above settings:
Before proceeding to the DTRS setup, RECALL THE SETUP as illustrated
above and SWITCH OFF THE 328.