Need help?Do you have a question about the Tascam DA-98 and is the answer not in the manual?
General| Brand | Tascam |
|---|---|
| Model | DA-98 |
| Category | Recording Equipment |
| Language | English |
Connect audio via TDIF cable between 328 and DTRS for digital transfer.
Connect BNC Wordclock for synchronization and MIDI for timecode/control.
Configure the 328 as the Wordclock Master device, setting sample rate.
Set Tape Port A to TDIF and wordlength to 16 bit for DA machines.
Configure the 328 for MMC controls with DTRS, selecting 'Tascam DTRS' setup.
Store the 328 configuration settings into a user setup location for later recall.
Configure DA-78HR menus for System, Audio, Timecode, and MIDI settings.
Set DA-88 to receive external clock and use TDIF digital input.
Configure DA-88 for MMC control via SY-88 board DIP switches.
Set DA-98 to receive external clock and use TDIF digital input.
Configure DA-98 control protocol (MIDI/9-Pin) and track arming.
Configure DA-98 timecode settings and MTC output.
Details compatibility differences between DA-88 generations and required system boards.
Explains MMC for DA series machines and necessary hardware for DA-38/DA-88.
To Next Page
