Task Force Tips EDUCTOR 125 Series - User Manual

20 pages

Save Page as PDF

To Next Page

©Copyright Task Force Tips, Inc. 2004 - 2017 LIU-330 November 16, 2017 Rev08

MANUAL:

EDUCTOR 125 SERIES IN-LINE

MANUAL FOR SAFE OPERATION AND MAINTENANCE

WARNING

Read instruction manual before use. Operation of this device without understanding the manual

and receiving proper training is a misuse of this equipment. Users who have not read and

understood all operating and safety instructions are not qualiﬁ ed to operate this eductor. This

instruction manual is intended to familiarize ﬁ reﬁ ghters and maintenance personnel with the

operation, servicing, and safety procedures associated with the eductor. This manual should be

kept available to all operating and maintenance personnel.

TASK FORCE TIPS, INC.

MADE IN USA • www.tft.com

3701 Innovation Way, Valparaiso, IN 46383-9327 USA

800-348-2686 • 219-462-6161 • Fax 219-464-7155

Inlet Pressure:

200 psi (13.8 bar)

160 psi (11 bar)

145 psi (10 bar)

Concentration Settings

Oﬀ , 1/4%, 1/2%, 1%, 3%, 6%

Models: 60 gpm (225 l/min)

95 gpm (360 l/min)

120 gpm (450 l/min)

125 gpm (475 l/min)

Maximum

Back Pressure:

130 psi (9 bar)

100 psi (6.9 bar)

95 psi (6.5 bar)

Other manuals for Task Force Tips EDUCTOR 125 Series

Instructions For Installation, Operation And Maintenance16 pages

Questions and Answers

M
michaelroseAug 18, 2025
What to do if Task Force Tips EDUCTOR 125 Firefighting Equipment eductor picks up too much foam concentrate?
- C
  Cathy WheelerAug 18, 2025
  If your Task Force Tips Firefighting Equipment eductor is picking up too much foam concentrate, consider the following: * The percentage knob may be set too high: Turn the knob to the desired percentage. * The eductor inlet pressure might be incorrect: Set the eductor inlet pressure to the pressure specified on the labels. * The metering head could be mismatched: Ensure you are using the correct metering head for the body.
O
Olivia CraigNov 2, 2025
Why is my Task Force Tips EDUCTOR 125 producing weak or no foam?
- R
  roberto94Nov 2, 2025
  There are several reasons why your Task Force Tips Firefighting Equipment might be producing weak or no foam: * The foam tank might be empty: Refill the tank. * The percentage knob may be set too low or to OFF: Adjust the knob to the desired percentage. * The percentage ball could be plugged: Remove the meter head and clear any debris. * The hose lay might be incorrect: Correct the hose lay according to AHJ-approved training. * The eductor inlet pressure may be incorrect: Set the eductor inlet pressure to the pressure specified on the labels. * The hose might be kinked: Straighten any kinks in the hose. * The concentrate intake hose could be clogged: Clean any debris from the concentrate intake hose. * The valve in the nozzle might not be fully open: Fully open the valve. ...