64
Variant: Machine with wet battery set
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Failure to observe these instructions may result in inad-
equate cleaning results or even floor damage.
-
• The machine must be switched off.
• Disconnect the battery from the machine at the battery dis-
connection socket.
• Lower the suction nozzle.
• At the bottom left and right on the
front side of the machine you will find
the battery compartment release.
• Unscrew both screws and remove
them.
• At the bottom left on the front side of
the machine you will find the battery
compartment release.
• Press the release (e.g. with a screw-
driver) into the intended opening and
lift the tank until it locks.
• Tank position before change of posi-
tion.
• Stand behind the machine.
• Carefully open the battery compart-
ment until the driving handle is on the
ground.
• Carefully open the battery compart-
ment until the driving handle is on the
ground.
• Switch the machine on (main switch
button with 755B and key switch with
855B).
The display lights up briefly.
The battery level indicator notifies
you that the machine is ready for op-
eration. (In case of malfunctions,
please see page 70).
• By gently pushing the switch bracket
drive into the direction of movement,
the machine is set into motion. If you
let go of the driving switch, the ma-
chine will stop.
• Position the tools under the tool unit.
• Switch the machine on.
The indicator elements lights up briefly.
• Unlock the foot pedal and lower the
tool slowly.
While lowering the brush drive will
slowly start to pulse. In this way the
tool is centered and engaged.
The brush drive display lights up
To Next Page
Loading...
