65
- Diversey recommends using cold water, as hot water
will adjust to the ground temperature as soon as it
comes into contact with the ground. Thus there are no
advantages to using hot water.
Using unsuitable products (e.g. products containing
chlorine, acids or solvents) may cause harm to health
and severe damage to the machine.
- The filling level mark on the tank corresponds to the
mark in the dosage cup. The type of machine is also
noted in the dosage cup!
-
- Please contact your customer service.
The objects could be catapulted by the rotating tool, and
thereby cause injuries to people and damage to the en-
vironment.
• The machine must be switched off (main switch).
• Position the suction nozzle (2) below
the suction nozzle holder (1).
• Press the foot pedal down until the
suction nozzle holder engages.
• Attach the suction hose to the con-
nector.
• The machine must be switched off (main switch).
• Put your hand into the opening be-
tween tank cover and tank.
Palms upwards.
• Open the tank cover until the support engages in the tank
wall.
• Remove the dosage aid.
• Fill the fresh water tank with water.
Maximum filling level (page 65).
• Tip the tank cover back into its original position and press
it down until it locks.
0.5% 1/2 1 x 1/2
MAX 1 x MAX
1% 1/2 1 x MAX (2 x 1/2)
MAX 2 x MAX
• Fill the product you have measured
with the dosage cup into the fresh
water tank.
• Slightly lift the tank cover.
• Push the tank cover support slightly inwards.
• Close the tank cover.
• By pushing gently on the front part of the tank cover you
lock the tank.
To Next Page
Loading...
