30
Squeegee setting for the swingo 3500
If you experience an uneven suction result, the settings of the squeegee should
be corrected. Proceed as follows to do this:
Before carrying out the adjustment, check that:
• the blades are not damaged (replace).
• the suction unit is not damaged.
Height setting (Fig. A)
• Lower the squeegee.
• Pull out the key and apply the parking brake (refer to page 25).
• Unscrew the hexagonal nut.
• Turn the Allen screw left or right.
The distance between the floor and the running wheel (with the blades standing
vertically) must be between 1-3 mm.
• Retighten the hexagonal nut.
• Check the result during the cleaning and refer to angle of inclination (Fig B).
Angle of inclination(Fig. B)
• Switch of the brush drive and the suction unit.
• Pull out the key and apply the parking brake (refer to page 25).
• Unscrew the Allen screws (nos. 1 to 4) on the suction unit adjustment (half a
turn).
• Insert a screw driver into the slot in the cam and hold it in position while
unscrewing the Allen screw No.5.
• Only change the angle of inclination in small steps using the cam.
• Keep the screwdriver in this position while tightening the cylindrical screws
numbers 1 to 5.
• Check the result and correct it again if necessary.
Malfunctions
A correct angle has been achieved when the tip
of the rear blade (x) is distributed over the
complete width of the suction unit.
To Next Page
