25
I25 I24 I23 I22 I21 I20 I19 I18 tr th sl se tr sv pt pl no nl it fr fi es en de cz
Preparation for operation/Operation
Batteries
Safety measures when working with batteries:
Recharging procedure using an external battery charger (traction block
batteries and rechargeable batteries)
After completing the charging and with immediate use:
Maintenance of batteries (wet batteries)
Daily, after charging:
Monthly after charging:
Preparation for use after charging:
Closing battery compartment:
Parking brake
Locking:
Unlocking:
Adjust the seat
Driving
The driving direction and speed can be controlled with the steering wheel and
drive pedal, the speed is easily adjusted with varying amounts of pressure to the
pedal.
Attaching tools
Check:
• that the brushes are not below the red marking and that the bristle length is
no less than 1 cm.
• the pad for wear before using.
• Protective goggles must be worn when working on the
batteries.
• Do not subject batteries to an open flame or heat as there is a
danger of explosion from the electolytic gas present in the
cells!
• No smoking!
• Danger of chemical burns!
Caution:
The battery must always be clean and dry. Do not place any
metallic objects on the battery.
Caution:
Batteries may only be installed or dismounted by customer
service personnel or specialists approved by Diversey who are
aware of all the safety regulations that apply here!
Caution:
Please follow the instructions of use for your battery charger!
Caution:
Battery compartment must be open during charging.
Caution:
When maintenance of batteries takes place, they must be
disconnected from the machine!
• Pull out the key and apply the parking brake (refer to page 25).
• Push the driver seat forward so that it rests on the steering wheel, and open
the battery cover.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Connect the battery plug with the external battery charger.
• Switch off the battery charger.
• Disconnect the battery charger.
• Connect the battery to the machine with the battery disconnection socket.
• Fold back the driver's seat.
• Measure the acidity in 3 or 4 cells.
It should be approx 30°.
The battery is discharged when the acidity reduces to approx. 18°.
• Please note the measurements into the battery booklet.
• Please check the electrolyte, and if needed, fill it with distilled or desalinated
water up to 10mm above the separators.
• Measure the acidity in every cell.
• Please note the measurements into the battery booklet.
•Check:
-Connectors, cables, cable attachments and that the poles are screwed in
tightly.
• Reconnect the battery plug to the machine.
• Re-cover the battery compartment and return the driver seat into its normal
position.
• First press down the brake pedal (1) and then
the parking brake (2).
Release the brake pedal, and the machine is
locked.
• Press the brake pedal fully down.
The machine is unlocked.
• Pull out the key and apply the parking brake (refer to page 25).
• Pull the lever on the left side of the driver's seat
and slide to the desired position.
• Push the lever back in, once the seat has been
corrected.
Check the seat locking device!
• Unlock the parking brake (refer to page 25).
• Unlock the parking brake (refer to page 25).
• Switch on the keyswitch.
The display lights up.
The battery indicator displays that the machine is
ready for operation
(in case of malfunction, refer to page 30).
• Choose the driving direction by using the drive /
reverse lever.
• Drive the machine to its destination and then release the drive pedal.
• Pull out the key and apply the parking brake (refer to page 25).
Working with worn out, damaged and or wrong tools, could result
in possible damage to floors or their protective layers.
1
2
To Next Page
Loading...
Need help?
General
