103
Service, maintenance and care
The maintenance of the machine is a prerequisite for impec-
cable operation and a long service life.
Service intervals
TASKI machines are high-quality machines that have been
checked for safety in the factory and by authorized inspectors.
Electrical and mechanical parts are subject to wear and aging
after a longer period of use.
Service center
Please always indicate the type and number of the machine
whenever you contact us for order placing or in case of mal-
functions.
The required data are provided on the nameplate of your ma-
chine. The address of your closest TASKI service partner is
provided on the last page of these instructions of use.
Blade replacement
Attention:
Use original TASKI parts only; otherwise,
any warranty and liability claims will ex-
pire.
Attention:
In order to rule out unintended machine
functions, before starting maintenance
works the following must always be carried
out
- the machine must be switched off,
- the key removed and
- the emergency stop confirmed.
Legend:
◊ = whenever cleaning is completed, ◊◊ = every week,
◊◊◊ = every month, ⊗ = service lamp
Activity
◊
◊◊
◊◊◊
⊗
Page
Loading batteries ● 95
Replenishing distilled water (wet-cell
batteries). Observe the service sheet of
the battery supplier!
●96
Draining and cleaning the recovery and
fresh water tank (Flextank)
● 102
Check the intake and suction filter for
contaminations and clean them
●
Clean all yellow marked parts ●
Clean the brushes ● 102
Clean the squeegee, check the blades
for wear and change them, if necessary
● 101
Wipe the machine using a damp cloth ● 102
Clean the seals of the tank lid, check
them for cracks and replace them, if
necessary
●
Check parking brake and emergency
stop button
●96
Maintenance and service program car-
ried out by Diversey service techni-
cians
●
• In order to maintain operational safety and
readiness for use, the machine must be ser-
viced whenever the maintenance indicator
lights up (factory setting is 650 working
hours) or at least once a year.
• Undo the four socket screws (1, 2, 3, 4).
• Separate the squeegee body from the squeegee core (5,
6).
• Remove the blades (7, 8).
• Clean the squeegee body and both squeegee cores under
running water.
• Mount the "turned" or new blades onto the squeegee core.
• Reinsert the squeegee core into the squeegee body.
• Retighten the four socket screws.
EN
To Next Page
Loading...
Need help?
General