89
ECO mode
Spot mode
Starting the machine using the program button
Cleaning start
Battery capacity - end of operational readiness
The battery level indicator provides information on the avail-
able operating time.
• Once the red display starts flashing, there are still approx.
10 minutes left for any remaining work.
• After this period, the brush unit and – 30 seconds later –
the squeegee are lifted. The red display switches to contin-
uous light.
• Now 10 more minutes remain for driving the machine to the
charging station. Then the machine is automatically
switched off.
• To restart the machine, the batteries must be charged for
several hours until the minimum level has been reached.
• The ECO mode is activated by pressing the
ECO mode ON/OFF button.
This reduces the speed of the suction motor.
Set the dosage of the cleaning solution to
level 2 and the brush pressure to level 1.
Notice:
If necessary, the cleaning solution and
brush pressure can be manually adjusted
in ECO mode.
The ECO mode is suitable for smoother
floors without joints.
• The spot mode is activated by pressing the
spot mode ON/OFF button.
By doing so, the slow approach is activated
for 90 seconds, the dosage of the cleaning
solution is set to level 6 and the brush pres-
sure is set to level 3.
Notice:
If necessary, the cleaning solution and
brush pressure can be manually adjusted
in spot mode.
The spot mode is suitable for heavily
soiled floors.
• By pressing the program button for the next
operation start or work step, all machine
functions are started on the basis of the
functional values last used.
Notice:
The corresponding function is deleted by
pressing any function button.
The suction motor is still on for a specified
time in order to reduce dripping. The dis-
play flashes until the suction motor is
switched off.
Notice:
The preset values can be adjusted at any
time during operation.
The values preset when switching off the
machine are stored and will be
automatically activated when restarting
the machine.
Notice:
Pressing the program button when the
cleaning process is finished will start an
optimized program for the end of opera-
tion.
See instructions on page 90 in the "Auto-
matic process" chapter.
Settings and activated functions are
saved.
• If the machine is switched on and the
operator is standing on the running
board, the machine starts moving as
soon as the driving switches are op-
erated. If selected, the brush unit is
started and the cleaning solvent sup-
ply is open.
The speed is controlled by the posi-
tion of the driving switches.
When the driving switches are re-
leased, the machine is automatically
decelerated until it stops and the
parking brake is activated.
The cleaning solvent supply is
closed, and the brush unit is stopped
with some delay.
Notice:
The supply volume of the cleaning solution
is adjusted to the corresponding working
speed. (IntelliFlow)
Attention:
When working in heavily furnished or nar-
row zones, the slow approach ON/OFF
button must be pressed. (Display lights up)
The maximum working speed is reduced,
and thus so is the risk of accidents.
• Pressing this button once more will
override this restriction, and the
display disappears.
If the red display on the battery level
indicator lights up, you must drive the
scrubber dryer to the battery charger.
To Next Page
Loading...
