88
I25 I24 I23 I22 I21 I20 I19 I18 I17 I16 tr sv sl pt pl no nl it fr fi es en de da cz
Dosing:
Dosing examples:
Beginning work with the machine
Manual program start
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when
handling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Attention:
The use of inappropriate products (e.g.
products containing chlorine or acid) may
damage or destroy the machine.
Information on the packing
of the product
Tank
capacity
Product
volume per
tank filling
0.5% 50ml for 10l
of water
113l 0.5l
1% 100ml for 10l
of water
113l 1.1l
2% 200ml for 10l
of water
113l 2.2l
3% 300 ml for 10l
of water
113l 3.3l
• Fill the appropriate product into the dosing cup and pour
the content into the fresh water tank (Flextank). Repeat the
procedure until the required dosage is reached.
• The dosing cup remains in the Flextank after dosage.
Notice:
TASKI offers an automatic dosage feature
as an option; It is possible to mount it addi-
tionally. Please contact your customer ser-
vice.
Attention:
Always wear slip-resistant shoes and
appropriate working clothes when working
with this machine!
• When operating the machine, always place
both hands on the driving handle to ensure a
safe operation of the machine.
Attention:
Start familiarization with the machine by
making your first driving attempts in a free
area.
• Stand on the running board.
Notice:
Check whether the emergency stop button
is released.
• Switch on the machine (key switch).
The display lights up briefly.
• Press the Suction unit ON/OFF
button.
The display lights up, the suction motor
starts and the squeegee is automatically
lowered to the operating position.
• Press the Cleaning solution supply ON/OFF
button.
The display lights up.
The cleaning solution supply is started when
the brushes rotate.
• Select the desired dosage by pressing the +/
- buttons from level
1-6.
Notice:
To protect the environment, you should
calculate the lowest level which is
sufficient for good cleaning results.
• Press the Brush drive ON/OFF button.
The display lights up, the brush unit is low-
ered and the engaging process starts auto-
matically.
• Select the desired brush pressure by
pressing the +/- buttons from level 1-3.
Notice:
Always calculate and select the lowest lev-
el which is sufficient for good cleaning re-
sults. Thus you will optimize power
consumption and increase the service life
of the machine.
To Next Page
Loading...
Need help?
General