30
28. Maintenance
The following maintenance schedule should be followed for proper machine operation:
MAINTENANCE ITEM DAILY WEEKLY
□ Drain and clean tank X
□ Clean tank basket lter X
□ Remove and clean canister lters X
□ Clean squeegee and pick up area X
□ Inspect pick up tube for obstructions X
□ Inspect squeegee for wear and adjust, ip, or replace as necessary X
□ Clean caster wheels X
□ Inspect pads and brushes for wear. Flip or replace as necessary. X
□ Perform Emergency Stop Button check X
□ Perform front cover interlock check X
□ Perform parking brake and safety light check X
□ Perform touch shield check X
□ Perform the oor sensor check X
□ Replace canister lters X
□ Inspect pickup hose and replace as necessary X
□ Inspect hinges and lubricate as necessary X
□ Apply grease to squeegee pivot bracket X
□ Inspect battery box ball bearings and lubricate if necessary X
□ Clean undercarriage X
28.1. Daily Maintenance Points
• Strainer Basket
Empty large items into the trash and rinse thoroughly.
• Primary Solution Filter
Remove the primary solution lter from the machine. Rinse and gently clean dirt and debris from the lter
using a soft bristle brush.
• Blue Secondary Filters
Remove both blue secondary lters from the back of the machine. Rinse and clean both lters. Allow
lters to air dry if possible. Visually inspect the condition of both lters and replace as necessary
• Squeegee Assembly
Disconnect the squeegee assembly from the SWINGOBOT 1650. Rinse the squeegee and wipe clean.
Hair and other debris may hinder results by leaving streaks on the oor. Visually inspect the condition of
the squeegee blades and rotate or replace as necessary. Check the condition of the frame gasket and
replace as necessary.
• Pads & Brushes
Remove pads or brushes from the machine. Rinse thoroughly and replace as needed.
• Solution Tank Seals
Clean and visually inspect the solution tank seal.
• Solution Tank
Tank should be drained, rinsed and cleaned at the end of every shift.
To Next Page
Loading...
Need help?
General
