tau speed 2 User Manual

7 & 8 NOT IN USE
9 & 10 ELECTRONIC FRICTION ADJUSTMENT
The system is highly sensitive to any variation in speed of travel due to any obstructions.
Adjust as follows:
OFF OFF Maximum
ON OFF Medium maximum
OFF ON Medium minimum
ON ON Minimum
SETTING TRAVEL (LIMITS) TIME
1. Place JMP1 into “MEMO” bridge
2. Press OPEN/CLOSE push button and make sure that the first movement of gate is closing phase
(if you open gate slightly you can ensure easier that this happens). If gate travels wrong way reverse
motor polarity.
3. After gate having closed, in about 2 seconds the gate will open fully. Ensure that gate comes to a
"stop" you have installed.
4 Replace JMP1 into "NORMAL" bridge as your limits have now been set.
SETTING AUTO CLOSE TIME - REQUIRED ONLY IF AUTO
CLOSING IS NEEDED
(Time for which gate stays open before closing automatically)
1. Place JMP1 into "MEMO" bridge.
2. Press OPEN/CLOSE push button and make sure that the first movement of gate is closing phase
(if you open gate slightly you can ensure easier that this happens). If gate travels wrong way reverse
motor polarity.
3. After gate having closed, in about 2 seconds the gate will open fully. Ensure that gate comes to a
"stop" you have installed.
4. Now the gate is fully opened wait for the period of time you want the gate to stay opened before
closing automatically and then push OPEN/CLOSE push button.
5. Replace JMP1 into “NORMAL” bridge as your limits and auto close times have now been set.
TO CHANGE ABOVE TIMES PLACE JMP3 INTO RESET POSITION FOR TWO TO THREE SECONDS ONLY AND THEN JMP1
INTO “MEMO” AND FOLLOW ABOVE INSTRUCTIONS
FOR ANY FURTHER INFORMATION PLEASE CONTACT OUR TECHNICIANS AT 305-691-7711
ALL CARE HAS BEEN TAKEN IN COMPILING THIS SET OF INSTRUCTIONS HOWEVER AFW ACCESS SYSTEMS
TAKES NO RESPONSIBILITY FOR ANY ERRORS OR OMISSIONS.

tau speed 2 Specifications

General

Brand	tau
Model	speed 2
Category	Gate Opener
Language	English