INTERFACOM, S.A.
Inst TX52_TX40_007_en.doc 10
RECOMMENDATIONS FOR THE ELECTRICAL INSTALLATION
− Disconnect the positive terminal on the battery until the whole electrical
installation is completed.
− Any manipulation of the taximeter or of the external lights must be done while
the taximeter is disconnected from the power supply
− Always take the positive and negative directly from the battery in order to avoid
false contacts and to obtain a more filtered power supply.
− Always connect the cables to the battery by means of a terminal, never by
winding the wires onto the contact.
− If the cables cross a plate to reach the taximeter they should go through a
protective rubber casing.
− If the cables are too long they should be cut to the required length and not rolled
up under any circumstances.
− If the vehicle has a radio transmitter, separate its installation from that of the
taximeter as far as this is possible.
− If it is possible no element that is connected to the taximeter should be fixed to
the same support as the aerial of the radio.
− If you need to show the SOS alert on the rooflight, you should ask for a special
tariff. Rooflight must be prepared to show SOS signal.
To Next Page
