INTERFACOM, S.A.
Inst TX52_TX40_007_en.doc 11
− 3. SEALING
3.1. SEALING
− Seal Nº1: Seals the taximeter box, preventing access to the electronic board.
− Seal Nº2: Seals the connectors cover, so it seals the electrical installation.
− Seal Nº3: seals the cover of the tariff charger connector
− On TX52 the sealing is on the sides
− On TX40 the sealing is on the front:
1 2 3
The taximeter kit is normally ready for sealing with a sticker seal. In some regions it is
necessary to have a cable seal. If you need this kind of seal, the taximeter kit should
include an antiturn angle and screws with a hole for the cables
To Next Page
Loading...
