Why is my Taylor-Dunn Utility Vehicle lacking power?
A lack of power or slow operation in your Taylor-Dunn Utility Vehicle can stem from several causes, including dragging brakes or parking brakes, discharged or defective batteries, worn drive gears, front end misalignment, or a defective speed control.
Why is the steering hard on my Taylor-Dunn Utility Vehicle?
Hard steering on your Taylor-Dunn Utility Vehicle could be due to dry lube points in the steering linkage, a damaged king pin or ball joint, or low tire pressure.
Why does my Taylor-Dunn Utility Vehicle steering pull in one direction?
If the steering on your Taylor-Dunn Utility Vehicle pulls in one direction, it could be caused by a front end misalignment or low tire pressure.
What causes abnormal noise in my Taylor-Dunn Utility Vehicle?
Abnormal noises in your Taylor-Dunn Utility Vehicle can arise from worn drive gears or bearings, worn front or rear axle bearings, loose lug nuts, or worn motor bearings.
What causes excessive steering play in Taylor-Dunn Utility Vehicle?
Excessive steering play in your Taylor-Dunn Utility Vehicle may be caused by worn ball joints, a mis-adjusted or worn steering gear, or loose steering linkage.
Why is the brake pedal low on my Taylor-Dunn Utility Vehicle?
A low brake pedal on your Taylor-Dunn Utility Vehicle can result from worn brakes (1/16" wear limit), low brake fluid, or brakes that are out of adjustment.
Why is there an oil leak in the rear bearing area of my Taylor-Dunn Utility Vehicle?
An oil leak in the rear bearing area of your Taylor-Dunn Utility Vehicle could be due to a failed rear wheel bearing or gasket, or because the drive is overfilled.
Why is the brake pedal soft or spongy on my Taylor-Dunn Utility Vehicle?
A soft or spongy brake pedal on your Taylor-Dunn Utility Vehicle is likely due to air in the brake lines.
Defines the duties and accountability of owners, operators, service personnel, and passengers.
Explains the manual's purpose, scope, and intended audience for vehicle operation and service.
Outlines critical safety procedures, operational issues, and checks for vehicle use.
Identifies and explains the function of all vehicle controls and instruments.
Details procedures for inspecting, adjusting, and servicing the front axle components.
Covers inspection, adjustment, bleeding, and replacement of brake system parts.
Provides guidance on battery cleaning, testing, charging, watering, and replacement.
Guides users through diagnosing electrical system issues and component failures.
Provides essential preliminary steps and warnings before starting troubleshooting.
Details troubleshooting procedures for the Lestronic II® battery charger.
Provides an exploded view and part numbers for front axle components.
Illustrates and lists parts for the vehicle's steering system.
Shows exploded views and part numbers for front and rear brake assemblies.
General| Brand | Taylor-Dunn |
|---|---|
| Model | B0-012-10 |
| Category | Utility Vehicle |
| Language | English |
To Next Page