Taylor 1528 - Alarm

2. Press and hold the “SET/AL” button.The
unit will beep and the alarm’s hour digits
will flash.
3. Press “+C/F” or “-PMCE/RCC” to
change the hours. Press “SET/AL” to enter.
The minutes will flash.
4. Press “+C/F” or “-PMCE/RCC” to
change the minutes. Press “SET/AL” to
enter.The unit will return to the clock dis-
play.
5. A icon above the time indicates
Alarm 1 is active.The unit will return to the
clock display after approximately 15 sec-
onds, or press “MODE” until the clock dis-
play returns.
To set two alarms:
Press the “MODE” button until A2 appears.
Repeat programming steps for A1.
A icon above the time indicates
Alarm 2 is active.
9
Press and hold SET/AL
Alarm 1 is active
Alarm 2 is active
Hour digits flash
Press +C/F or -PMCE/RCC to
change hours.
Press SET/AL to enter hours.
Minutes digits flash.
Repeat to set minutes.