17
Models 750, 751, 754, 774, 794 Operating Procedures
Note: There are two gaskets and two front bearings
for the Models 754, 774, and 794 door, one for each
freezing cylinder.
Figure 8
Slide the two o-rings into the grooves on the prime
plug(s). Apply an even coat of Taylor Lube to the
o-rings and shaft(s).
Figure 9
Note: There are two prime plugs for the Models 754,
774 and 794 door, one for each freezing cylinder .
Insert the prime plug(s) into the hole(s) in the top of the
freezer door , and push down.
Figure 10
Step 4
Install the freezer door. Insert the baffle rod(s) through
the opening in the beater(s) and seat the door flush
with the freezing cylinder . With the door seated on the
freezer studs, install the handscrews. Tighten equally
in a crisscross pattern to insure the door is snug.
Note: On Models 754, 774 and 794, short
handscrews go on the bottom and the long
handscrews go on top.
Figure 11
To Next Page
Loading...
