2-16
CONTROLS AND SYSTEMS
Model 810, 812, 820, 822, 828 Series
Controls and Systems
2
9. Remove the USB flash drive from the USB port and
re-install the USB cable cap on the USB connector.
Note: Grills built prior to serial number M1035495
will require the front control panel to be re-installed.
10. Repeat the software loading procedures for each
control.
11. After the new software is installed, the control will
revert to the default settings for all menu items. Load
the menu items previously saved to the USB back
into the control(s).
Loading Store Menu Items to USB
The same USB flash drive that was used to load software
into the grill can be used to perform this procedure.
1. Remove the USB cable cap from the USB connector
to access the USB port.
Note: Grills built prior to serial number M1035495
will require the front control panel to be lowered to
access the control display boards.
2. Insert the USB flash drive into the USB port.
3. Press and hold the PROGRAM key for 5 seconds to
enter the Program mode.
Figure 2-34
4. Enter the operator password STORE1 and press the
OK key.
Figure 2-35
5. Press the MENU EDIT key.
Figure 2-36
6. Press the STORE MENU TO USB key.
Figure 2-37
To Next Page
Loading...
