TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)9C-409C-40
flash may be corruptflash may be corrupt
(contact Spicer Off–(contact Spicer Off–
Highway).Highway).
9999..9900 SS WWrroonng g ffiirrmmwwaarre e iiss
flashed into the APC.flashed into the APC.
The controller revertsThe controller reverts
to a ”shut down”to a ”shut down”
mode and will forcemode and will force
neutral 0.neutral 0.
Flash the correctFlash the correct
firmware into thefirmware into the
APC.APC.
Wrong firmware isWrong firmware is
flashed into the APC.flashed into the APC.
Flash the correctFlash the correct
firmware into thefirmware into the
APC.APC.
9999..9955 SS CCAAN N ppeeaak k llooaadd
detected : APC tem-detected : APC tem-
porarily could notporarily could not
process all incomingprocess all incoming
messages, due to anmessages, due to an
excessive peak ofexcessive peak of
CAN requests.CAN requests.
Controller will replyController will reply
on the CAN mes-on the CAN mes-
sages which aresages which are
available in its buffer.available in its buffer.
No acNo actiotion reqn requesuestedted.. OveOverlorload oad of inf incomcom--
ing CAN messagesing CAN messages
to the APC.to the APC.
No action requested.No action requested.
The codes listed below are called ’Exceed Parameter’ codes and are not so much codes that report a problem, but ratherThe codes listed below are called ’Exceed Parameter’ codes and are not so much codes that report a problem, but rather
indicate a certain machine operating state.indicate a certain machine operating state.
These codes give an indication of the machine operating state in regard to some programmed limits that may beThese codes give an indication of the machine operating state in regard to some programmed limits that may be
exceeded.exceeded.
ExceedExceed
CCooddee TTyyppee EExxppllaannaattiioonn CCoonnttrroolllleerr’’s s AAccttiioonn DDrriivveer r AAccttiioonn
EE00..0011 EE TThhe e vveehhiicclle e ssppeeeed d iis s ttooo o hhiiggh h ttoo
make the requested downshift.make the requested downshift.
The controller will disable the down-The controller will disable the down-
shift in order to shift in order to protect the transmis-protect the transmis-
sion, until the vehicle speed comession, until the vehicle speed comes
below the downshift limit.below the downshift limit.
The driver should slow down theThe driver should slow down the
vehicle, in order that the requestedvehicle, in order that the requested
downshiflt can be made.downshiflt can be made.
EE11..0011 EE TThhe e vveehhiicclle e ssppeeeed d iis s ttooo o hhiiggh h ttoo
make the requested directionmake the requested direction
change.change.
The controller will not allow theThe controller will not allow the
direction change to protect thedirection change to protect the
transmission and will place thetransmission and will place the
transmission in neutral, until thetransmission in neutral, until the
vehicle speed comes below thevehicle speed comes below the
direction change vehicle speeddirection change vehicle speed
limit.limit.
The driver should slow down theThe driver should slow down the
vehicle, in order that the requestedvehicle, in order that the requested
direction change can be made.direction change can be made.
EE22..0011 EE TThhe e eennggiinne e ssppeeeed d iis s ttooo o hhiiggh h ttoo
make the requested directionmake the requested direction
change or the requested re–en-change or the requested re–en-
gagement of the direction.gagement of the direction.
The controller will not allow theThe controller will not allow the
direction change or re–engagementdirection change or re–engagement
of the direction, until the of the direction, until the engineengine
speed comes below the directionspeed comes below the direction
change or the direction re–engage-change or the direction re–engage-
ment engine speed limit.ment engine speed limit.
The driver should slow down theThe driver should slow down the
engine, in order that the requestedengine, in order that the requested
direction change or direction re–en-direction change or direction re–en-
gagement can be made.gagement can be made.
ExceedExceed
CCooddee TTyyppee EExxppllaannaattiioonn CCoonnttrroolllleerr’’s s AAccttiioonn DDrriivveer r AAccttiioonn
EE33..0000 EE TThhe e rreedduucceed d vveehhiicclle e ssppeeeed d lliimmiittaa--
tion is active.tion is active.
The controller is limiting the vehicleThe controller is limiting the vehicle
speed to the reduced vehicle speedspeed to the reduced vehicle speed
limit.limit.
No action is requested, the vNo action is requested, the vehicleehicle
speed is limited due to request.speed is limited due to request.
EE33..0011 EE TThhe e rreedduucceed d vveehhiicclle e ssppeeeed d lliimmiittaa--
tion is active, however the vehicletion is active, however the vehicle
speed is above the limit.speed is above the limit.
The controller is limiting the vehicleThe controller is limiting the vehicle
speed to the reduced vehicle speedspeed to the reduced vehicle speed
limit, but detects a higher limit, but detects a higher vehiclevehicle
speed.speed.
The driver should slow down theThe driver should slow down the
vehicle, in order that the vehiclevehicle, in order that the vehicle
speed comes below the reducedspeed comes below the reduced
vehicle speed limit.vehicle speed limit.
EE33..0022 EE TThhe e vveehhiicclle e ssppeeeed d iis s aabboovve e tthhee
maximum vehicle speed limit.maximum vehicle speed limit.
The controller is limiting the vehicleThe controller is limiting the vehicle
speed to the maximum vehiclespeed to the maximum vehicle
speed limit, but detects a higherspeed limit, but detects a higher
The driver should slow down theThe driver should slow down the
vehicle, in order that the vehiclevehicle, in order that the vehicle
speed comes below the maximumspeed comes below the maximum
To Next Page
Loading...
