14-314-3TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
When the housing is filled, the vent plug portWhen the housing is filled, the vent plug port
permits air to be removed.permits air to be removed.
9.9. FilFill the hl the hydrydrauliaulic tanc tank witk with the sh the specpecifiifieded
amount of fluid (refer toamount of fluid (refer to Changing TheChanging The
Hydraulic FluidHydraulic Fluidinin Section 22Section 22) until hydraulic) until hydraulic
fluid flows from the brake cooling output portfluid flows from the brake cooling output port
of the brake housings.of the brake housings.
10.10. Re-install the Re-install the vent plug and vent plug and brake cooling out-brake cooling out-
put plug. put plug. Tighten Tighten both to a torque vboth to a torque value ofalue of
60-75 ft-lbs (80-100 N60-75 ft-lbs (80-100 N⋅⋅m).m).
11.11. Place the transmissPlace the transmission in Neutral and ion in Neutral and start thestart the
engine. engine. When the When the hydraulic fluid hydraulic fluid level goeslevel goes
POSITION PLUGPOSITION PLUG
HERE TO FILL ORHERE TO FILL OR
CHECK LEVELCHECK LEVEL
POSITION PLUGPOSITION PLUG
HERE TO DRAINHERE TO DRAIN
BRAKE COOLINGBRAKE COOLING
INPUT PORTINPUT PORT
BRAKE COOLINGBRAKE COOLING
OUTPUT PORTOUTPUT PORT
BRAKE APPLYBRAKE APPLY
PORTPORT
BRAKE COOLINGBRAKE COOLING
DRAIN PLUGDRAIN PLUG
VENTVENT
PLUGPLUG
DRAINDRAIN
PLUGPLUG
To Next Page
Loading...
