Taylor TX360L - Troubleshooting; Cracks in welds

28-328-3TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
MAINMAIN
ROLLERSROLLERS
SLIDE BEARINGSLIDE BEARING
BLOCKSBLOCKS
Illustration 28-3. Illustration 28-3. Optional Carriage Optional Carriage With Fork With Fork PositionersPositioners

TroubleshootingTroubleshooting
PPrroobblleemm CCaauussee CCoorrrreeccttiioonn
1.1. CCrarackcks in s in wweleldsds
(refer to(refer to SIRRSIRRin thein the
AppendicesAppendices))
Notify TaylorNotify Taylor
Machine Works,Machine Works,
Inc. for properInc. for proper
repair procedures.repair procedures.
1.1. MMetetal fal fatatigigueue..
2.2. OvOvererloloadadining.g.
3.3. RRouough tgh tererrarainin..
4.4. TTravravellelling wing with lith load ioad in an unn an unrecrecom-om-
mended travel position (excessivemended travel position (excessive
height and / or fully side-shifted,height and / or fully side-shifted,
one side or the other).one side or the other).
5.5. SeSevevere re duduty ty cycyclcleses..
6.6. TTryirying to ung to use fose fork pork positsitioneioners whrs whileile
loaded.loaded.
1.1. HavHave cre crackacks is in wn weldelds rs repaepairedired
immediately.immediately.
2.2. RefRefer ter to Coo Correrrectiction 1on 1. an. and avd avoidoid
overloading the truck.overloading the truck.
3.3. RefRefer ter to Coo Correrrectiction 1on 1. an. and, id, if pof pos-s-
sible, avoid operating truck onsible, avoid operating truck on
rough terrain.rough terrain.
4.4. RefRefer ter to Coo Correrrectiction 1on 1. an. and td thehe
Operator’s Guide for proper travel-Operator’s Guide for proper travel-
ling positions.ling positions.
5.5. HavHave cre crackacks is in wn weldelds rs repaepairedired
immediately.immediately.
6.6. Use Use forfork pok positsitionioners ers onlonly wy whenhen
forks have no load.forks have no load.
https://www.forkliftpdfmanuals.com/