MPPT charge controller User Manual
Please refer to following overall wiring diagram of SP as shown in Figure 3-4.
PV+
PV- BAT-
BAT+
Solar Mate
PV Array
PV Array-
PV Array+
Battery
BAT+
BAT
-
Figure 3-4 Wiring diagram of Solar Mate
Step2：Please select the appropriate wire according to section 3.4.3.
Step3：Please connect BAT- to battery negative，and connect BAT+ to battery positive.
Step4：Please connect PV- to PV array negative，and connect PV+ to PV array positive.
Step5：Please make sure the wire is connected correctly and reliably.
To Next Page
