Swapping antenna type
The radio comes with a built-in antenna, but it can be changed to an external SMA connector so different
antennas can be used. Remove the mainboard from the housing to expose the housing - be careful when
unhooking the U.FL antenna connector, remove the rubber retainer first.
Unscrew the two screws holding the stock antenna in place, remove the antenna and metal bracket. Put
the rubber retainer on the new connector and put the plastic adapter on the back of the SMA connector.
Screw the new SMA connector in place using the same screws and re-assemble the radio.
To Next Page
Loading...
