FAQ
● My Tango does not bind to the receiver - both are blinking slowly green
○ Update your build-in Crossfire to 3.73 (beta) or later and retry
● After binding, the receiver shows a double pattern and I get no signals in BF/ INAV/ …
○ This is an authentication error on the crossfire. To solve it:
■ Shut down your drone and the Tango
■ Power up the Tango
■ Set it in Bind-mode
■ Power up the receiver
■ Push the bind button on the receiver
○ After a few seconds the green led on the receiver should switch to a constant green light
● I get movements BF/ INAV/ … on the 4 sticks but not from any switch
○ You need to assign the switches in the “Mixer” page of your model to a channel you’d like it
to be. For detailed informations on the mixer page, have a look at Painless360’s opentx
video series
● The switches on channel 9 and following do not show any movement in BF
○ Open the
Agent Lite/ Crossfire receiver/ General/ Mode: 12Ch
● I can no longer see the Frequency setting and the output power is limited
○ Your Crossfire is in a region-lock mode. This mode makes sure that non-allowed settings
are not available. If you have set it the by accident, here is how you can unlock it
● In the Agent X/ Lite/ M the Crossfire and WiFi module do not show up
○ Navigate in the Model settings, page 1 and disable the external module
Manual written and designed by ivc.no in cooperation with TBS and Kamikatze-fpv.de.
To Previous Page
Loading...
