TBS6909 Multi Standard Tuner Card User Guide
Linux open source driver model
Working mode: Multiswitch mode: (Mode 0)
If you are using quad LNB, you can directly connect the 4 cables to the 4 ports of TBS6909.
If you are using quattro LNB, you have 4 cables (V/L,V/H,H/L,H/H), connect the right one to
TBS6909 like the above picture ( input 0- input 3 should be connected to V/L,V/H,H/L,H/H
respectively).
If you are using C band or Ku band single, then two inputs are enough, you just need to connect
the cables to input 0 and input 2.
Input 0 Interface: You can only receive DVB-S/S2 TV channels from low-frequency noise V/L TV
signals. After connecting to these TV signals through “Input 0 Interface”, you can receive SD/HD
TV channels from the 8 different satellite transponders simultaneously.
Input 1 Interface: You can only receive DVB-S/S2 TV channels from high-frequency noise V/H TV
signals. After connecting to these TV signals through “Input 1 Interface”, you can receive SD/HD
TV channels from the 8 different satellite transponders simultaneously.
Input 2 Interface: You can only receive DVB-S/S2 TV channels from low-frequency noise H/L TV
signals. After connecting to these TV signals through “Input 2 Interface”, you can receive SD/HD
TV channels from the 8 different satellite transponders simultaneously.
Input 3 Interface: You can only receive DVB-S/S2 TV channels from high-frequency noise H/H TV
signals. After connecting to these TV signals through “Input 3 Interface”, you can receive SD/HD
TV channels from the 8 different satellite transponders simultaneously.
Notes: If you would like to receive full TV channels from V/H satellite TV signals simultaneously,
you need to connect your satellite TV signal cable to the corresponding “Input” interface.
To Next Page
Loading...
