Need help?Do you have a question about the TC Electronic Finalizer 96K and is the answer not in the manual?
General| Type | Mastering Processor |
|---|---|
| Sampling Rate | Up to 96 kHz |
| Bit Depth | 24-bit |
| Number of Channels | 2 |
| Analog Inputs | XLR |
| Analog Outputs | XLR |
| Stereo Width | Adjustable |
| THD+N | < 0.005% |
| Digital Inputs | AES/EBU, S/PDIF |
| Digital Outputs | AES/EBU, S/PDIF |
| Dynamic Processing | Compressor, Limiter |
| Power Supply | 100-240 VAC, 50-60 Hz |
| Connectivity | AES/EBU, S/PDIF, Optical, Analog I/O |
Optimizing Analog-to-Digital conversion and clock settings.
Managing asynchronous digital inputs and sample rates.
Understanding input status and supported digital formats.
Syncing with external clocks and digital output options.
Setup recommendations for ADAT integration and remote control.
Configuring analog or digital external processing inserts.
Adding analog warmth with harmonic distortion.
Modifying stereo width and balance.
Dynamic Equalizer settings including Threshold, Ratio, Attack, Release, Frequency, and Curve.
Configuring EQ parameters like frequency, gain, and slope.
Setting up analog or digital external processing inserts.
Converting between stereo and Mid/Side signals.
Controlling stereo width in three frequency bands.
Optimizing signal level and headroom.
Smoothing overshoots and preventing digital distortion.
Basic Threshold, Ratio, Attack, and Release settings.
Advanced parameters like Side Chain/Delay.
Adjusting Threshold, Ratio, Attack, and Release for bands.
Fine-tuning Attack, Release, and Side Chain/Delay.
To Next Page
