9
Restoring the factory settings
You can restore the original settings for the water quantity.
1. Press the On/Off button to switch off
the machine.
2. Press and hold the left and right
coffee buttons and then press the
On/Off button.
The three coffee buttons flash and
a signal will sound in confirmation.
3. Release the buttons. The factory settings for the water quantity have been
restored.
Standby mode
If no button is pressed for about nine minutes, the machine will automatically
switch to standby mode. The On/Off button and coffee buttons will go out. The
machine will then use very little energy. This is both a safety function and a way
to save energy. However, you should still always switch the machine off using the
On/Off button.
To disconnect the machine completely from the mains power, remove the
mains plug from the wall socket.
To switch the machine back on,
simply press the On/Off button.
m
Cleaning
Cleaning the casing
Wipe the casing with a soft, damp cloth. m
Also wipe the compartment for the used capsule container with a soft, dampm
cloth as required.
Rinsing the water tank daily
Rinse out the water tank daily under running water. This will preventm
limescale deposits or other particles clogging the filter on the bottom of the
water tank.
Thoroughly cleaning the water tank weekly
The water tank should be cleaned once a week.
Wash the water tank in warm water with a mild washing-up liquid. Rinse it outm
thoroughly under running water and dry it. The tank is not dishwasher-safe.
DANGER – risk of fatal electric shock
Remove the mains plug from the wall socket beforecleaning the•
device.
Never immerse the machine, mains plug or mains cord in water •
or any other liquids.
Do not clean the machine with a water jet. Clean it only as•
described in the following instructions.
CAUTION – material damage
Do not use any caustic, aggressive or abrasive products for cleaning.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
