7
5. Press the coffee button that corresponds to the capsule you have inserted.
The brewing process starts and stops automatically.
As is the case with professional
espresso machines, for espresso and
caffè cream capsules a small quantity
of coffee is pre-brewed. This enhances
the aroma. This process can be identi-
fied by the short pause at the beginning
of the brewing process. Filter coffee is
prepared without a pre-brewing
process, just like with standard coffee
machines.
Tip: You can adjust the strength of the
coffee by adjusting the quantity of
water. Refer to the section “Adjusting
the strength (amount) of the coffee” for
information on how to do this.
If you would like to stop the brewing process prematurely, press the samem
coffee button again while brewing.
6. Before removing the coffee cup, fold back
the lever as far as it will go, so that the
capsule falls into the used capsule con-
tainer.
7. Then fold the lever down again so that the
capsule opening is closed.
=
white
coffee button
black capsule
(espresso)
=
yellow
capsule
(caffè crema)
yellow
coffee button
=
blue
coffee button
blue
capsule
(filter coffee)
Default settings (amounts are approximate):
Espresso 40 ml I Caffè crema 125 ml I Filter coffee 125 ml
1. Press the On/Off button to switch on the
machine.
The On/Off button and coffee buttons
flash and the machine starts to heat up.
The machine is ready for operation once
all the buttons remain permanently lit.
A short signal will also sound.
2. Place an empty cup beneath the coffee
spout.
3. Fold back the lever as far as it will go and
insert a capsule as illustrated with the lid
facing forwards.
The capsule must be intact:
Do not pierce it and do not remove the
capsule lid or insert a misshapen capsule!
4. Fold the lever fully down.
This action pierces the base and lid of the
capsule.
Brewing coffee
To Next Page
Loading...
Need help?
General
Weight and Dimensions
