16
Disable SIM PIN
1. When the SIM PIN feature is enabled, click
.
2. Enter the current SIM PIN code.
3. Click Apply.
Advanced settings
WAN
Basic
Set up the WAN connection mode and modify related parameters under this option. You can
set the connection mode to DHCP, PPPoE or Static IP.
DHCP
Dynamic Host Configuration Protocol (DHCP) is a client or server
protocol that automatically provides you with an Internet Protocol
(IP) host. The IP address and related configuration settings such as
subnet mask and default gateway are all automatically assigned.
PPPoE
Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol
that is mainly used for DSL services whereby individual users
connect to a modem using an Ethernet connection.
Enter the username and password provided by your network service
provider, and click Apply.
Static IP
Access the internet using a fixed IP address, subnet mask, gateway
IP address and Primary DNS server. These information should be
provided by your network service provider.
MAC clone
When the MAC clone function is enabled, multiple client devices can connect to the CPE
and access the internet.
Your current MAC address is displayed in this option. Click Reset to set a new MAC address.
Click Clone to copy your host MAC address.
LAN
The default gateway address is 192.168.1.1, and the default subnet mask is 255.255.255.0.
With the DHCP server function enabled, IP addresses will be assigned automatically to client
devices in the network. If the DHCP server function is disabled, the CPE will not assign IP
addresses to the connected client devices. The IP address must be entered on each client
device.
Bandwidth Control
This feature allows you to view information about online devices, and set upload bandwidth
limits or download limits for devices if needed.
IP filter
By default, any device connected to your CPE network is allowed to access the internet.
To Next Page
Loading...
Need help?
General
