Factory Alignment Specification of normal SIACP
Page 7 of 12
1.6 HDCP Test
For HDCP compliancy, it’s needed to check whether the HDCP key has been well set.
2.FinalAssemblyAlignment
2.1 FactoryMenu
Follow the below steps to pop-up the Factory Menu in case of “FactoryKey” is disable
:
-
press RemoteControl key “MENU” to display main menu
- Select “Picture” and press “OK” key to enter the picture submenu
- Select “Contrast” item
-
press the subsequence RemoteControl keys “9”, “7”, “3” and “5”
Press RemoteControl key “Return” To pop-up the Factory Menu in case of “FactoryKey” is
enable.
The status of “Factory Key” can be changed in
Factory Menu->Hotkey
Press RemoteControl “OK” key or “RIGHT” key to enter the submenu.
Press RemoteControl “Menu” key to go back to the root menu.
Press RemoteControl “RIGHT”or “LEFT” key to change the values.
Press RemoteControl “OK” key run the function.
Press RemoteControl “Exit” key exit the factorymenu.
2.2 Entering to “P” Mode
Turned on the factory key to enter into “P” mode.The TV will display the following info in
bottom left corner in “P” mode.
-main version ***
-project ID ***
-P/PS/D ***
2.3 White Balance Alignment
Make sure that the picture mode is “vivid”, enter to “P” mode(turned on the factory key) and
switch off “Pic. Enhance” in Factory Menu-> White Balance before white balance alignment .
VGA,CMP, DTV,CVBS_PAL Color Coordinates are relative to HDMI.
CVBS_SECAM and CVBS_NTSC Color Coordinates are relative to CVBS_PAL.
Warm and Cool Color Coordinates are relatives to Normal mode.
Only HDMI(YUV 720p@60Hz) input requires color temperature adjustment.
All the Relative
Matrix Offsets should be set while doing alignment.
To Next Page
Loading...
Need help?
General
