2
4. Power indicator
•Solid blue: the device is on.
•Blinking blue: the device is performing factory reset or
firmware update.
•Off: the device is off.
5. Power button
•Press for 3 seconds to power off your device.
•Press for 1 second to power on your device.
6. WPS button
Press the button for 3 seconds to enable the WPS function.
The WPS function will be automatically disabled if a WPS
connection is not established within 2 minutes.
7. WAN/LAN port
Used to connect to an internet source or wired devices
such as computers or switches.
8. LAN port
Used to connect to wired devices such as computers or
switches.
9. Telephone port Connect a telephone to make or answer calls.
10. Power connector Used to connect to the power adapter.
NOTE
When the CPE downloads and installs software updates, you will see the power
indicator flashes in blinking blue. Do not power off your CPE during this process as
it may cause device malfunction.
1. Micro USB port It is intended for debug use only.
2. Nano SIM card slot Insert a nano SIM card in the slot.
3. Reset button
Use a paperclip to press the button for 3 seconds to reset
the device.
To Next Page
Loading...
Need help?
General
