TCL P733W

28 29
5 Specications
Product Name
3.1 Channel Sound Bar with Dolby Audio, DTS Virtual:X and
Wireless Subwoofer
Sound Bar
• Power Supply: AC 100-240V~50/60Hz
• Power consumption: 38W
• Power consumption at standby mode:
≤
0.5W
Impedance: 6
Ω
• Frequency response: 160Hz-20KHz
• Dimensions (WxHxD): 35.4"x2.7"x3.9" / 900x68x98mm
• Weight: 5.1 lbs (2.3 kg)
• Operating temperature: 0°C - 45°C
Wireless subwoofer
• Power Supply: AC 100-240V~50/60Hz
• Power consumption: 50W
• Power consumption at standby mode:
≤
0.5W
• Frequency response: 40 Hz-120 Hz
• Frequency range: 5732MHz-5848MHz
• Max transmitting power: 13dBm
•
Dimensions (WxHxD): 9.8"x14.4"x8.7" / 248x365x220mm
• Weight: 12.3lbs (5.6 kg)
Bluetooth
• Bluetooth version: 5.2, Bluetooth profile - Bluetooth
stereo supported (Advanced Audio Distribution Prole -
A2DP; Audio Video Remote Control Prole - AVRCP)
• Frequency range: 2402 Mhz – 2480 Mhz
• Max transmitting power: 15dBm
Remote control
• Distance/Angle: 6m/ 30°
• Battery type: 1.5V AAA battery x 2, user replaceable.
6 Notice
Notice for USA
FCC Information
Warning
Changes or modications to this unit not expresslyapproved
by the party responsible for compliance could void the
user's authority to operate the equipment.
Note
• This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician
for help.