12 13
7 8 9
10
Notes
• Check the installation location before you mount the
Sound Bar on the wall (see ‘Mount your Sound Bar on
the wall’ on page 10).
• You may consider to connect the cables first before
mounting the Sound Bar on the wall.
Install/replace the remote control
batteries
Warnings
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Caution
• The battery contains perchlorate material, handle it
with care. For information, refer to www.dtsc.ca.gov/
hazardouswaste/perchlorate
1 Open the battery compartment, remove the old batteries
if necessary.
2
Place two new AAA batteries (Zinc Manganese batteries)
into the battery compartment with the correct polarity (+/-).
3 Close the battery compartment.
Setup is complete. Your Sound Bar is ready to use. For
more information about how to access different connection
options on your Sound Bar, see the following chapter.
To Next Page
Loading...
