L2E Repair Document TCL Communication Ltd.
VF1300 Level 2E Repair Document
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
Note:Speaker can be removed from PCBA by using soldering iron. (Temperature :Lead-free technology
330℃±10℃,time :5~6 seconds)
Step5: Take off 13 screws from Furnished Mid-Frame and then remove the frame (set the torques at
0.7kgf.cm if using electric screw driver, set the torques at 0.8kgf.cm if using manual screw driver).
Battery shall not be separated from Furnished Mid-Frame as it is firmly adhered to the Furnished
Mid-Frame by adhesive. If Furnished Mid-Frame swap is needed, swap Furnished Mid-Frame along
with the battery.
To Next Page
Loading...
