Outlet pump cleaning (twice a year is recommended)
Tear down outlet pump
protective cover with a
blade or a coin as shown
in the figure;
Unscrew the pump
cover (beware of water
residue) and take out
clothes residue and
clean it up completely
until the blade can
rotate freely;
Fit on the pump cover
and screw it to make
sure there is no water
leakage as shown in the
figure. Put on the
protective cover!
nPay attention to the spillover of detergent that may cause inconvenience when
adjusting (like tilting and moving, etc.) the machine (draw out the case before
adjusting).
nA little detergent will flow into water box when drawing the case, this is normal. Try
not repeatedly opening and closing the case in case of detergent loss;
uUse tap water or brush to wash detergent case and syphon pipe;
uAs fig. b (d) shows, open the case (pick it up slowly) and take out syphon
plate (lift it up);
uAs fig. a (c) shows, pull the case and press down the limit rod; pull the whole
drawer out;
uRestore case cover and syphon pipe, and push the drawer in.
nIf there is detergent or softener residue in the case:
Routine maintenance
Caution: Beware of scald!
nTurn off the tap!
nMaintain the machine after the hot water is cooled in case of scald;
!
To Next Page
Loading...
Need help?
General
