TCM FB10-7 - INSPECTION

B ALWAYS INSPECT BEFORE OPERATING
@@——@%—@———®®@®-®
The operator should always inspect the truck before each use to
verify that all essential safety features are working. Any abnormality
is to be reported to the supervisor, who is responsible for correcting
it.
B PERIODIC INSPECTIONS ARE MANDATORY
Monthly and annual inspections must be performed thoroughly, and
any abnormality promptly repaired. Only a certified expert who has
the advanced skills and equipment is required to conduct the
inspections. Preserve the inspection logs for at least three years.
FOR SUPERVISORS
Ш REPLACE SAFETY PARTS REGULARLY
Recommended replace-
Name of Safety Parts ment interval (years)
Cups and dust seals of master cylinder
and wheel cylinders 1
2 | Power steering hose 2
3 | Reserve tank tubing 2-4
4 | Steering actuator rubber boots 2
5 | Lift chain 2-4
6 | Load handling means hoses 1-2
Certain critical parts must be replaced at regular intervals. Since it
is difficult to detect wear on the above parts by visual inspection,
they must be replaced after a certain period of time. Failure to do
so would result in a falling load or runaway truck.
Ш NEVER USE AN UN-MAINTAINED TRUCK
A truck that has not passed an inspection must never be operated.
Hang a sign on the truck and remove the ignition switch, to make
sure no one uses it. Then report the problem to the supervisor and
wait for the repair to be completed.