TCM FB10-7 - BEFORE STARTING LIFT TRUCK; STARTING LIFT TRUCK

BEFORE STARTING LIFT TRUCK
A CAUTION
• It takes about 1 second after the key switch is turned
on, to make the control circuit ready for functioning to
allow the truck to start.
* Do not place the F/R lever in forward “F” or reverse
“R” before the key switch is turned on; otherwise the
truck might not start.
If this is the case, return the F/R lever to neutral “М”.
* Do not bottom the accelerator pedal rapidly. It is
dangerous.
A CAUTION
Make sure there is no one around the truck and let other
workmen and bystanders know you are starting up by
honking.
1) Pull back the lift lever to raise the forks 5 to 10 cm from the
ground or floor surface.
2) Pull back the tilt lever to tilt back the mast fully.
3) Pull back the lift lever again to raise the forks 15 to 20 cm from
the ground or floor surface.
4) Make sure there is no one around the truck and let other
workmen and bystanders know you are starting up by honking.
PROPER OPERATION
STARTING LIFT TRUCK
A CAUTION
Press the brake pedal fuily before shifting the F/R lever
into forward "F" (or reverse “R”).
A CAUTION
When traveling in reverse, look in the direction of travel
and be alert for pedestrians, other trucks or obstacles
in your path of travel. Do not rely too much on the
sideview mirrors.
1) Step on the brake pedal.
2) Place the F/R lever into forward "F" (or reverse "R").
3) Release the parking brake.
4) Remove your foot from the brake pedal and step down the
accelerator pedal gradually.
5) You can control the traveling speed by stepping on the
accelerator pedal.
^N" NOTE
Do not keep your foot on the brake pedal after starting the
truck.